An electric water heater is one of the primary equipment around the house. If it breaks down all of a sudden, then it can throw the entire household go for a toss. Finding a technician for heating repair in Staten Island is not possible always so it is better that the homeowner has some know how of how to go around things in case the heating unit starts to throw tantrums. There can be various issues that stems from your heating unit and that can range anything from discoloration, leaks odor, and noise. Homeowner themselves can troubleshoot the water heater problems until an expert walks in and gives it a thorough look.

How to troubleshoot the water heater?

There are some very basic steps to deal with a problematic water heater:

Before beginning with handling the water heater issues make sure to turn the power off.

Dealing with Leaks

The water heater might be leaking due to various reasons. It can be because of faulty temperature pressure relief valve overheating excessive pressure leak from an overhead or adjacent plumbing connection and more. When checking the T & P that is pressure relief valve first place a bucket under the overhead pipe. Then open the valve and flush it properly to clear out all the debris. If the leak still persists then repair or replace the same. For reducing the extreme pressure and heat then lower the thermostat setting. It is necessary to check for loose pipe connections and tighten it as necessary. The heating element bolts need to be looked into as well and tighten them. If the leak still remains then replacing it is a wise decision. In the last step run a check for ant leaks in the storage tank. Leaks in the storage tank can happen due to corrosion or poor bad o-rings.

water heating system repair queens

Discoloration or odor

Your water heater should not be giving out rust-colored water. If it is then that can be due to corrosion inside a glass-lined tank or a sacrificial anode rod that is failing. In case the anode rod is failing then it needs to be replaced with a magnesium anode rod. A anode rod that is gradually giving away will also release hydrogen. The problem can be addressed by flushing the heater. If the smell still persists then it is better to replace the heater with a plastic lined one.

Noise from the heater

A low and rumbling noise from the heater is not good news and probably is due to boiling water caused often by overheating because of sediment build up. Look out for a high-pitched whining noise from the heater which can be as a result of scales build-up. Flushing the water heater is a solution.

Issues with water temperature

If there is issue with the water temperature then that can be because of thermostat issues or the water heater might be undersized. Both of them needs to be taken a look at by the technician so that you are spared of heating repair in Queens.

There is no point being stuck with a faulty heating unit. Though DIY is always not suggested and preferred, that is something you can do to stall a bad situation until the technician is at the doorstep ready to fix things.

Also Read: Common Water Boiler Problems and How to Deal With Them